Suction Kit
Cod. Kit D. int. mm.22 mt.7

>> Cod. Kit D. int. mm.22 mt.7

Phone
0545 77114
Fax
0545 77420
E-Mail
commerciale@contecosrl.com

Head office and plant:
Via Bastia Vecchia 124
48020 S.Bernardino di Lugo (RA)

Our suction kits are made of a spiral of rigid PVC covered with a layer of plastic PVC to form a hose with an internal diameter of mm.22 smooth internally. Our kit is resistant to the depression created in the suction side of the working pump and to the pressure when the pump stops. At the both sides are fixed original patented fittings that allow you to connect the kit, easily and without the use of tools, to all the pumps generally in trade with attacks male or female threaded 1” or 1.1/4”.

The interior of the tube is perfectly smooth and presents no diameter discontinuity: fittings are fixed outside pipe and do not reduce the water transition useful when using nozzles fixed with bands. The positive consequence is the reduction of pressure losses with corresponding increases of the performance of the pump  in delivery capacity and in prevalence. The systems of joining threaded and in particular the turning nut and the nipple are compact dimensions while guaranteeing a diameter of useful passage of more than 25 mm.

The following table shows the identification codes of the kit of standard production usually present in stock.

  • Cod. 102212400 Kit D.int. mm.22 Lenght m.4 with turning nut in PA6  1”  and nipple in PVC 1”x1”.
  • Cod. 102212401 Kit D.int. mm.22 Lenght m.4 with foot valve in PA6 1”, turning nut in PA6 1” and nipple in PVC 1”x1”.
  • Cod. 102212700 Kit D.int. mm.22 Lenght m.7 with turning nut in PA6  1”  and nipple in PVC 1”x1”.
  • Cod. 102212701 Kit D.int. mm.22 Lenght m.7  with foot valve in PA6 1”, turning nut in PA6 1” and nipple in PVC 1”x1”.
  • Cod. 102212000 Kit D.int. mm.22 Lenght m.10 with turning nut in PA6  1”  and in PVC 1”x1”. May be jointed to one or more identical Kit to form pipes each length.

All the kits are tested to withstand continuous pressure of 18 bar at 20°C without distortion or losses.

The standard colors pipe are black for the rigid spiral and clear crystal for the plasticized part. Of course there are other possible combinations of colors with the customer’s needs.

All the codes may be equipped with a set of additional fittings consisting of a reduced nipple 1.1/4 " x 1" and a sleeve reduced 1.1/4” x 1" that make possible connection also with male or female 1.1/4 ".

All kits made by Conteco can be personalized or executed on customer’s request.